Baroness LM331, Service Manual, Page: 116 / 165

Adjustment of Traveling Pedal
Important
Evenly screw in the left and right screws of the
elbow to be installed to the traveling rod.
Important
When tightening the traveling rod lock nut, be
careful of the position of the elbow and
confirm that the rod moves smoothly.
Important
Be sure to check that the following have been
adjusted before adjusting the traveling pedal.
Adjustment of neutral position of the piston
pump
Adjustment of traveling relay lever
Start the engine.
Lower the mower unit.
Stop the engine.
Open the hood.
Remove the right-side floor panel.
Follow the steps below to adjust the traveling
rod.
If the traveling pedal base plate is not facing
directly up when the traveling relay lever is
facing directly up, the traveling rod needs be
adjusted.
Loosen the left and right lock nuts of the
traveling rod, and remove the nut from the
L ball joint on one side.
Adjust the traveling rod so that the
traveling pedal is facing directly up, and
install the L ball joint.
Tighten the nut.
Tighten the lock nut.
･
･
1.
2.
3.
4.
5.
6.
[1]
[2]
[3]
[4]
3 4 5
6
7
1
2
3
5
6
4
q5w4la-001
Adjustment of Traveling Pedal_001
1 Traveling relay lever
2 Traveling pedal base plate
3 Traveling rod
4 Lock nut
5 L ball joint
6 Nut
7 Spring washer
LM331
Main body
Page 6-8
Adjustment