Baroness LM331, Owner'S Operating Manual, Page: 59 / 103

Remove the ring nut, and then remove the
cup.
3 2
1
v1spa6-006
Cleaning of Water Separator_002
1 Ring nut
2 Cup
3 Element
Drain the water from the cup.
Clean the cup and element with diesel fuel.
Important
During installation, prevent contamination with
dirt or dust.
If the fuel is contaminated with dirt or dust
etc., the fuel injection pump and injection
nozzle will become worn.
Correctly install all parts in their original
positions.
Fill up the fuel tank with fuel, and then open
the fuel cock of the fuel filter.
Open the fuel cock of the water separator.
1
2
A
B
v1spa6-005
Cleaning of Water Separator_003
1 Fuel cock
2 Air-bleeding plug
A ON (open)
B OFF (close)
Loosen the air-bleed plug to bleed the air.
5.
6.
7.
8.
9.
10.
11.
When the cup is filled with fuel, close the
air-bleed plug.
If the engine does not start within 15
seconds after switching the ignition key to
the "START" position, wait at least 30
seconds, and then repeat the same
operation.
If there is still air in the cup after starting the
engine, bleed the air again.
Fuel Filter
Inspection of Fuel Filter
The fuel filter works to remove foreign objects
mixed into the fuel.
When the fuel flow becomes insufficient,
replace the fuel filter if necessary.
Make sure that there is no fuel leakage.
Make sure that the fuel filter is not damaged
or dirty.
Liquid Leakage
Inspection of Liquid Leakage
Caution
When performing maintenance on the
hydraulic system, lower the mower units.
Important
After approximately 50 hours of operation,
some tightened portions may be loosened and
liquid such as oil may leak.
Be sure to retighten the parts.
Check the bottom of the machine for
leakage of liquid such as oil, water, fuel,
etc.
Locate the leakage and identify the type of
liquid.
Ignoring leakage will cause further trouble.
12.
13.
1.
2.
1.
2.
Handling Instructions
LM331
Handling Instructions
Page 5-15
Inspection and Cleaning