Baroness LM3210A, Owner'S Operating Manual, Page: 94 / 167

Fuel
Inspection of Fuel Quantity
With the machine on a level surface, observe
the fuel level in the monitor to check the fuel
level.
1
2
FUEL LEVEL OIL PRES
guc5f6-009
Inspection of Fuel Quantity_001
1 Monitor
2 Fuel level
Fuel Supply
Warning
Do not supply additional fuel after the fuel
level indicates 100%.
If you supply too much fuel, it might overflow
from the fuel cap when you travel or work on a
slope.
Warning
Keep fire away while refueling.
Do not smoke.
Important
Use ultra-low sulfur diesel fuel (sulfur-free
diesel fuel).
Important
In case of lack of fuel, DPF regeneration can
not be performed.
If the monitor displays the warning message
"FUEL LEVEL LOW", immediately stop
operation, and then supply fuel (diesel).
The fuel tank capacity is approximately 51.0
dm
3
(51.0 L).
Note:
The factory default low fuel level is 10%.The
level can be changed optionally.
1
2
FUEL LEVEL OIL PRES
guc5f6-009
Fuel Supply_001
1 Monitor
2 Fuel level
Air Bleeding of Fuel System
Open the hood.
Set the key switch to the "ON" position and
then start the electromagnetic pump.
A priming pump is installed on the feed
pump.
Repeatedly press the top of the priming
pump with your finger until resistance is felt,
to bleed air.
Set the key switch to the "OFF" position.
Close the hood.
2
1
kou8ls-005
Air Bleeding of Fuel System_001
1 Feed pump
2 Priming pump
1.
2.
3.
4.
5.
LM3210A
Handling Instructions
Page 5-14
Inspection and Cleaning