Baroness LM3210A, Owner'S Operating Manual, Page: 151 / 167

Maintenance Item
Before Work
After Work
Every Week
Every 50 hrs.
Every 150 hrs. Every 250 hrs. Every 400 hrs. Every 500 hrs. Every 800 hrs.
Every 1500 hrs. Every 3000 hrs.
Every month
Every year
Every 2 years Every 4 years
When Required
Remarks
*6
Replace hydraulic
hoses (Moving part)
relating to steering
△
Replace hydraulic
hoses (Fixed part)
△
Backlap blades ○
Replace brake pads △
Replace brake cables
△
Regrind blades (Reel
cutter)
○
Grind/Replace
blades as and when
required
*5 Replace battery
△
*1: When biodiesel fuel is used, change the fuel filter cartridge, fuel hose and clamp bands with new
ones at
intervals half of the usual ones.
*2: Consult your local Baroness Dealer or local KUBOTA Dealer for this service.
The items above (*3 marked) are registered as emission related critical parts by KUBOTA in the
U.S. EPA nonroad emission regulation.
As the engine owner, you are responsible for the performance of the required maintenance on the
engine according to the above instruction.
Please see the Engine's Warranty Statement in detail.
*4: Refer to the Engine's Owner's Manual.
*5: Refer to the Battery's Owner's Manual.
The values for consumables are not guaranteed.
*6: Be sure to replace hydraulic hoses for steering cylinder and hydraulic hoses for hydraulic motor
of wheel relating to steering every two years.
List of Adjusted Value
Cutter adjustment spring 40.0 mm (1.575 in) Coil spring length
CR brush 0 - 1.0 mm (0 - 0.039 in) Gap between brush and rear roller
Fan belt
10.0 - 12.0 mm (0.39 - 0.47 in)
Slack when applying 98 N (10 kgf)
force to the belt at the middle point
Adjustment:237 - 403 N
Replacement:460 - 680 N
Measurement of belt tension by
using a sonic type tension meter
CR brush drive belt 5.0 - 6.0 mm (0.197 - 0.236 in)
Slack with 10.0 N (1.0 kgf) force
applied around center section
between belt pulleys
Brake
0.2 mm (0.0079 in)
Clearance between the brake disc
and the pad
1.0 mm (0.039 in)
Play at the connection of the inner
wire
･
･
･
･
･
･
･
Appended Table
LM3210A
Appended Table
Page 8-11
List of Adjusted Value