Baroness LM3210A, Owner'S Operating Manual, Page: 130 / 167

Change of Hydraulic Oil Suction Filter
Caution
Be careful with hot oil, which could cause
burns if it contacts your skin.
Important
When replacing the hydraulic oil filter, be sure
to drain the oil into a container and discard it
in accordance with local laws and regulations.
Important
If the hydraulic oil emulsifies or if it becomes
even slightly less transparent, change the oil
immediately.
Important
Use Shell Tellus S2M46 (or equivalent) as
hydraulic oil.
Important
Replace the intake port packing with a new
one.
On a level surface, lower the mower units,
and then stop the engine.
Remove the left tank cover.
Remove bolts, spring washers and
washers, and then remove the intake hose
joint fitting.
Remove the old suction filter and intake
port packing.
Remove all of the old liquid gasket from the
hydraulic tank.
Remove all of the old liquid gasket and the
intake port packing from the intake hose
joint fitting.
Wash and clean the intake hose joint fitting.
Apply liquid gasket to the new intake port
packing and then install it to the intake hose
joint fitting.
Install the new suction filter to the intake
hose joint fitting. 1.
2.
3.
4.
5.
6.
7.
8.
9.
Install the intake hose joint fitting to the
hydraulic tank.
1
6
2
3
4
5
7
6zi3qb-001
Change of Hydraulic Oil Suction Filter_001
1 Suction filter
2 Intake hose joint fitting
3 Bolt
4 Spring washer
5 Washer
6 Intake port packing
7 Hydraulic tank
Supply hydraulic oil until it reaches the
specified level.
"Hydraulic Oil Supply" (Page 5-7)
Start the engine and stop it after ten to
twenty minutes.
Check underneath the machine for
hydraulic oil leakage.
Install the left tank cover.
Change of Air Cleaner Element
A contaminated air cleaner element may cause
malfunction of the engine.
To maximize the life of the engine, replace the
air cleaner element at the appropriate times.
The timing for replacing the air cleaner
element is described below.
Replace the air cleaner element in
accordance with the Maintenance
Schedule.
If it is significantly contaminated, replace
it, even if the hours of operation do not
exceed the specified time.
Replace the air cleaner element by following
the same steps as for cleaning the air
cleaner.
"Cleaning of Air Cleaner Element" (Page
5-9)
10.
11.
12.
13.
14.
1.
[1]
[2]
2.
LM3210A
Maintenance
Page 6-30
Adjustment and Replacement