Baroness LM3210A, Owner'S Operating Manual, Page: 129 / 167

Check underneath the machine for oil
leakage.
Attach the left tank cover.
Change of Hydraulic Oil Filter
Change of Hydraulic Oil Line Filter
Caution
Be careful with hot oil, which could cause
burns if it contacts your skin.
Important
When replacing the hydraulic oil filter, be sure
to drain the oil into a container and discard it
in accordance with local laws and regulations.
Important
If the hydraulic oil emulsifies or if it becomes
even slightly less transparent, change the oil
immediately.
Important
Use Shell Tellus S2M46 (or equivalent) as
hydraulic oil.
On a level surface, lower the mower units,
and then stop the engine.
Remove the filter protecting plate.
3
1
2
ycfdh6-017
Change of Hydraulic Oil Line Filter_001
1 Filter protecting plate
2 Bolt
3 Filter cartridge
Loosen the old filter cartridge by hand and
remove it.
Lightly coat the packing of the new filter
cartridge with hydraulic oil, and then install
the cartridge.
7.
8.
1.
2.
3.
4.
Firmly tighten the filter cartridge by hand
until the packing contacts the mounting
surface.
And then tighten it with a half more turn.
1
ycfdh6-015
Change of Hydraulic Oil Line Filter_002
1 Cartridge filter
Supply hydraulic oil until it reaches the
specified level.
"Hydraulic Oil Supply" (Page 5-7)
Install the filter protecting plate.
Start the engine and stop it after hydraulic
oil warmed.
Check underneath the machine for
hydraulic oil leakage.
5.
6.
7.
8.
9.
Maintenance
LM3210A
Maintenance
Page 6-29
Adjustment and Replacement