Baroness LM3210A, Owner'S Operating Manual, Page: 117 / 167

Attach the wheel in a position within the range
of cutting height that suits your work
requirements.
To increase cutting height:
Loosen cutting height adjustment nut A,
tighten cutting height adjustment nut B,
then lower the rear roller.
Use the cutting height gauge to
determine the position, then tighten
cutting height adjustment nut A securely.
To decrease cutting height:
Loosen cutting height adjustment nut B,
tighten cutting height adjustment nut A,
then raise the rear roller.
Use the cutting height gauge to
determine the position, then tighten
cutting height adjustment nut B securely.
1
5
6
7
4
A
2
3
ut7d6z-004
Front Wheel Type_002
1 Reel cutter (cutting cylinder)
2 Front Wheel
3 Cutting height gauge
4 Bed knife (bottom blade)
5 Cutting height adjustment nut A
6 Cutting height adjustment nut B
7 Rear roller
A Cutting height
1.
[1]
[2]
2.
[1]
[2]
Adjustment of Cutter Adjustment Spring
If the diameter of the reel cutter (cutting
cylinder) becomes smaller, adjust the cutter
adjustment spring.
Adjust the blade engagement.
Loosen the pipe with cutter adjusting screw,
and then adjust the length of the spring coil
to approximately 40 mm (1.575 in.).
1
A
tv9pml-001
Adjustment of Cutter Adjustment Spring_001
1 Pipe with cutter adjusting screw
A 40 mm (1.575 in.)
Adjustment of Reel Cover
Note:
Depending on the specifications, this function
may not be available.
The angle of the reel cover can be adjusted.
Pull the right and left knobs securing the reel
cover to release it.
2
1
3
A
B
C
D
1qbdtn-003
Adjustment of Reel Cover_001
1 Reel cover
2 Knob
3 Cover adjustment plate
A Fully open
B 15 degrees closed
C 30 degrees closed
D Fully closed
1.
2.
1.
Maintenance
LM3210A
Maintenance
Page 6-17
Adjustment and Replacement