Baroness LM315GC, Service Manual

Page: 152 / 199

Roller
Front Roller
Wear of bearings due to frequent use and/or
damage of bearing etc. caused by invasion of
water may prevent smooth rotation of the roller.
Inspect and replace the parts such as the oil
seal or bearings.
Make sure that there is no play in the fit of
the roller pipe and the housing.
Make sure that there is no abrasion or
adhesion of the roller.
Make sure that there is no abrasion or rust
of the bearing and the housing and bearing
have no play.
Danger Danger
The reel cutter (cutting cylinder), bed knife
(bottom blade), and groomer blades are all
edged tools.
Handle them carefully, since they could cut
your hands and feet.
Caution
See the list in " "Tightening torques" (Page
3-6) ".
Note that the Baroness product warranty may
not apply to defects caused by incorrect
tightening etc.
Remove the front roller Assy.
Remove the oil seal and stop ring on the
left and right sides.
u5fjkf-001
1
2
Front Roller_001
･
･
･
1.
2.
1 Oil seal
2 Stop ring
Knock the side where the protruding roller
shaft is longer to remove the roller shaft.
u5fjkf-002
1
Front Roller_002
1 Roller shaft
Fix the removed roller shaft with a vise etc.
and then remove the bearing by using a
pulley remover.
u5fjkf-003
1 2
Front Roller_003
1 Bearing
2 Pulley remover
3.
4.
LM315GC
Operating Machine and Mower Units
Page 7-34 Inspection and repair of each section