Baroness LM315GC, Service Manual

Page: 141 / 199

Remove the special bolt and U nut fixing
the brush and pull out the brush in the
direction of the arrow.
spc9h1-002
3
1
2
4
Removal of CR Brush Driver Assy_002
1 Brush
2 Special bolt
3 U nut
4 Brush Driver
If the movement of the bearing of the brush
fulcrum metal Assy is bad, follow the steps
below to replace the bearing.
Remove the brush fulcrum metal Assy
from the rear roller bracket.
spc9h1-003
1
2
3
4
5
Removal of CR Brush Driver Assy_003
1 Rear roller bracket
2 Brush fulcrum metal Assy
3 Washer
4 Spring washer
5 Nut
3.
4.
[1]
For the brush fulcrum metal Assy,
remove the stop ring and then replace
the bearing.
spc9h1-004
2
3
1
Removal of CR Brush Driver Assy_004
1 Brush fulcrum metal
2 Bearing
3 Stop ring
Installation of CR Brush Driver Assy
Danger Danger
The reel cutter (cutting cylinder), bed knife
(bottom blade), and groomer blades are all
edged tools.
Handle them carefully, since they could cut
your hands and feet.
Caution
See the list in " "Tightening torques" (Page
3-6) ".
Note that the Baroness product warranty may
not apply to defects caused by incorrect
tightening etc.
For installation, reverse the removing
procedure.
[2]
1.
Op
er
at
in
g Mac
hin
e a
nd
Mo
we
r U
nits
LM315GC
Operating Machine and Mower Units
Page 7-23 Removal and installation of each section