Baroness LM315GC, Owner'S Operating Manual, Page: 79 / 86

Once the adjustment has completed, be
sure to lock with the nut.
1
A
cs6lrm-001
Adjusting Work Speed_002
1 Lock nut
A Length of the bolt
(#30421 - )
Depress the mower pedal to lower the
mower units.
Loosen the locknut on the side of the rod
head for the right cylinder to adjust the
length of the bolt.
Length of the bolt (Longer): Slower
Length of the bolt (Shorter): Faster
Once the adjustment has completed, be
sure to lock with the nut.
A
1
2
cs6lrm-002
Adjusting Work Speed_003
1 Rod head
2 Lock nut
A Length of the bolt
Adjusting the Neutral Position of the Piston
Pump
Caution
Make sure not to touch rotating tires.
1.
2.
･
･
Caution
When adjusting the neutral position, pay close
attention to abrupt start of the machine.
Place the jacks beneath the jack-up points,
and then lift the machine until all the tires get
off the ground.
If the machine moves forward or backward
while the traveling pedals are released, they
are not set to the neutral position.
Follow the steps below to make adjustments.
Stop the engine.
Place the jacks beneath the jack-up points,
and then lift the machine off the ground.
"Jack-up Points" (Page 5-7)
Make sure that no tires get contact with the
jack stand.
Start the engine, and rev it up to the
maximum rpm.
Adjust the neutral position.
Loosen the lock nut.
Rotate the camshaft slowly until the front
wheel stops.
Find the position where the front wheel
stops and lock the camshaft with the nut.
1
2
hsn2jo-010
Adjusting the Neutral Position of the Piston Pump_001
1 Lock nut
2 Cam shaft
1.
2.
3.
4.
5.
[1]
[2]
Maintenance
LM315GC
Maintenance
Page 5-17
Maintenance (Main Body)