Baroness LM315GC, Owner'S Operating Manual, Page: 70 / 86

Greasing
About Greasing
Since there may be adhesion or damage due
to lack of grease on moving parts, they must
be greased.
Add urea-based No. 2 grease in accordance
with the Maintenance Schedule.
Other locations where the specified grease or
lubricant is used are indicated in "Greasing
Points".
Add grease using the specified grease or
lubricant.
Greasing Points
Grease nipples are installed in the following
locations.
Add grease every 50 hours of operation.
However, add grease to the points according to
the schedule if their greasing periods are
specified.
2
4
11
2
2
1
7
3
5
9
1
10
6
2
8
1
8bq62b-229
Greasing Points_001
Location
No. of
greasing
points
1 Mower unit 36
2 Mower arm fulcrum 6
3 Belt tension lever 1
4 Neutral position area 1
5 Rear wheel pivot 1
6 Mower pedal shaft fulcrum 1
7 Flexible wire bracket 1
8 Traveling pedal shaft fulcrum 1
9 Rear wheel brake lever shaft 1
10 Flexible wire edge 3
11 Flexible wire 6
Mower unit
Each mower unit has 12 points (6 A and 6 B
points).
Add grease to A and B every 8 and 50
hours, respectively.
Right
A
A
A
B
B
B
8bq62b-149
Greasing Points_002
Left
A
A
A
B
B
B
8bq62b-150
Greasing Points_003
1.
LM315GC
Maintenance
Page 5-8
Greasing