Baroness LM315GC, Owner'S Operating Manual, Page: 61 / 86

Start the work following the procedure below.
Depress the traveling pedal.
Depress the mower pedal when the
mower unit reaches the collar of the
green.
Lower the mower units to start rotating the
reel cutters (cutting cylinders).
Note:
During the work, the reel cutters (cutting
cylinders) will rotate or stop in sync with the
up and down motion of the mower units.
Set the reel rotation switch to the "TRAVEL"
(reel stop) position after the operation
completed.
Reel Refreshing Operation
(#30727 -)
Warning
The reel cutter rotates while holding down the
up switch when the reel rotation switch is set
to the "MOW" (reel rotation) position.
Set the reel rotation switch to the "TRAVEL"
(reel stop) position except during mowing or
backlapping and using reel excess discharge
system.
Caution
Before using reel excess discharge system,
make sure that there are no people around
the machine.
Caution
The reel cutter rotates when using reel excess
discharge system.
Keep hands and feet away from moving parts.
Important
Do not press the up switch when the mower
unit is at lowered position.
Otherwise, the harness may get damaged.
Important
The reel cutter keeps rotating even if the
mower unit raised to the highest position while
holding down the up-switch.
7.
[1]
[2]
[3]
8.
Preventing lumps of clippings from falling
onto the green.
Use reel excess discharge system so that
the clippings inside the reel cutter can be
removed during mowing operation or when
discarding clippings.
Stop the engine.
Brush the clippings accumulated on the
bracket.
At the time the clippings comes inside of
the reel cutter.
Install the grass catchers.
Sit on the seat.
Start the engine.
Raise all mower units.
Set the reel rotation switch to the "MOW"
(reel rotation) position.
Hold down the up switch for about a
second.
While holding down the up switch, the reel
cutter rotates while the mower unit rising
and the clippings inside the reel cutter are
removed.
Set the reel rotation switch to the
"TRAVEL" (reel stop) position after the
operation completed.
Stop the engine.
Vehicle wash
When washing the vehicle after mowing
operation, the clippings can be removed with
the reel excess discharge system.
Stop the engine.
Set the transmission shift lever to the
"LAP" position.
Sit on the seat.
Start the engine.
Raise all mower units.
Set the reel rotation switch to the "MOW"
(reel rotation) position.
Stand on the right side of the machine and
hold down the up switch for about 2 to 3
seconds.
While holding down the up switch, the reel
cutter rotates while the mower unit rising
and the clippings inside the reel cutter are
removed.
Set the reel rotation switch to the
"TRAVEL" (reel stop) position after the
operation completed.
Stop the engine.
･
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
･
1.
2.
3.
4.
5.
6.
7.
8.
9.
Handling Instructions
LM315GC
Handling Instructions
Page 4-37
Cutting Work