Baroness LM315GC, Owner'S Operating Manual, Page: 32 / 86

Move the machine onto a level surface,
stop the engine, remove the drain plug
while the engine oil is warm, and then drain
the oil into a bowl.
Wind new sealing tape around the drain
plug, and then replace it in the engine.
1
gui678-012
Replacement of Engine Oil_001
1 Drain plug
Through the oil filling port, supply new
engine oil until the oil reaches a level in
between the upper and lower limit lines on
the oil level gauge.
Supply 1.0 dm
3
(1.0 L) of engine oil,
remove the oil level gauge, and then insert
it all the way to check the oil level.
After checking the oil level with the oil level
gauge, add more engine oil if it is
insufficient.
The engine oil quantity (including the oil
filter) is approximately 1.6 dm
3
(1.6 L).
Replace the oil filler cap.
1
2
bgmiun-011
Replacement of Engine Oil_002
1 Oil level gauge
2 Oil filling port
It will take a while for the supplied engine oil
to descend into the oil pan.
Check the oil level again 10 to 20 minutes
after filling the oil.
1.
2.
3.
4.
5.
6.
7.
Fuel
Inspection of Fuel Quantity
With the machine on a level surface, observe
the fuel gauge on the fuel tank to check the
fuel level.
1
guc5f6-007
Inspection of Fuel Quantity_001
1 Fuel gauge
Fuel Supply
Danger Danger
Do not supply fuel above the F (FULL) level of
the fuel gauge.
If you supply too much fuel, it might overflow
from the tank cap when you travel or work on
a slope.
Warning
Keep fire away while refueling.
Do not smoke while refueling.
Caution
Supply fuel before starting the engine.
Never remove the tank cap or supply fuel
while the engine is running.
When opening the tank cap, wait at least 1
minute after stopping the engine, and then
slowly open the cap to release the pressure in
the tank.
Opening the tank cap quickly may cause fuel
to burst out.
LM315GC
Handling Instructions
Page 4-8
Inspection Before Use