Baroness LM285, Owner'S Operating Manual, Page: 36 / 65

1 Reel cutter (cutting cylinder)
2 Front roller
3 Cutting height gauge
4 Bed knife (Bottom blade)
5 Cutting height adjustment nut A
6 Cutting height adjustment nut B
7 Rear roller
A Cutting height
Front Wheel Type
Adjust the cutting height to fit your cutting work.
You can adjust the front wheels in four stages.
(40~68mm) (33~47mm) (26~40mm) (19~33mm)
ut7d6z-001
Front Wheel Type_001
Attach the front wheels in a position within the
range of cutting height that suits your work
requirements.
To increase cutting height:
Loosen cutting height adjustment nut A,
tighten cutting height adjustment nut B,
then lower the rear roller.
Use the cutting height gauge to
determine the position, then tighten
cutting height adjustment nut A securely.
To decrease cutting height:
Loosen cutting height adjustment nut B,
tighten cutting height adjustment nut A,
then raise the rear roller.
1.
[1]
[2]
2.
[1]
Use the cutting height gauge to
determine the position, then tighten
cutting height adjustment nut B securely.
1
5
6
7
4
A
2
3
ut7d6z-002
Front Wheel Type_002
1 Reel cutter (Cutting cylinder)
2 Front Wheel
3 Cutting height gauge
4 Bed knife (Bottom blade)
5 Cutting height adjustment nut A
6 Cutting height adjustment nut B
7 Rear roller
A Cutting height
Adjustment of Cutter Adjustment Spring
If the diameter of the reel cutter (cutting cylinder)
becomes smaller, adjust the cutter adjustment
spring.
Adjust the blade engagement.
Loosen the pipe with cutter adjusting screw,
and then adjust the length of the spring coil
to approximately 40 mm (0.394 in).
1
A
tv9pml-001
Adjustment of Cutter Adjustment Spring_001
1 Pipe with cutter adjusting screw
A 40 mm (0.394 in)
[2]
1.
2.
LM285
Handling Instructions
Page 4-16
Adjustment Before Operating