Baroness LM2700, Service Manual

Page: 276 / 325

Important
Be sure to replace the bearing, oil seal and
packing with new ones.
Apply a profuse amount of grease on new
bearings and oil seals.
To bearings, apply grease like rubbing until
the grease leaks from the other side.
Also apply a profuse amount of grease to the
lip of the oil seal.
1
2
uxqrbr-002
Reel Housing_002
1 Ball bearing
2 Oil seal
Tap the bearing into the reel housing evenly.
Note:
Use a bearing driver to drive in the bearings
and oil seals.
uxqrbr-003
Reel Housing_003
5.
6.
Important
The stop ring has a specific installation
direction.
Install it in the correct orientation.
Install the stop ring onto the housing lid.
Tap the oil seal into the housing lid evenly.
Note:
Use a bearing driver to drive in the bearings
and oil seals.
Install the packing and housing lid onto the
reel housing with the bolt and spring washer.
Hydraulic Motor Housing
Wear of bearings due to frequent use and/or
damage of bearings etc. caused by invasion of
water may prevent smooth rotation of the reel
cutter.
Inspect and replace the parts such as the oil
seal or bearings.
Make sure that the hydraulic motor housing
does not have any crack.
Make sure that the spindle bolt and housing
bolt receptacles are not shaky.
Make sure that the bearing receptacle are
not shaky.
Danger Danger
Both the reel cutter (cutting cylinder) and the
bed knife (bottom blade) are edged tools.
Handle them carefully, since they could cut
your hands and feet.
Caution
See the list in "Tightening torques" (Page
3-5) .
Note that the Baroness product warranty may
not apply to defects caused by incorrect
tightening etc.
Remove the hydraulic motor housing from
the reel cutter. (See "Removal of Reel
Cutter" (Page 8-11) .)
7.
8.
9.
･
･
･
1.
LM2700
Operating Machine and Mower Units
Page 8-28 Inspection and repair of each section