Baroness LM2700, Service Manual

Page: 164 / 325

1 Notch
2 Parking brake stopper
With the parking brake at notch 5, adjust
adjusting nut A and adjusting nut B of the
parking brake switch to create a slight
clearance at the switch contact point.
1
2
3
67xzzh-006
Parking Brake Switch_003
1 Switch contact point
2 Adjusting nut A
3 Adjusting nut B
Important
If the switch contact point is pressed more
than a stroke of the switch, the switch may be
damaged.
Release the parking brake, and then make
sure that the switch contact point is pressed.
Follow the steps below to check the
operation of the parking brake switch.
While sitting on the seat with the parking
brake set to at least notch 5 and the reel
switch set to the OFF position, check that
the engine starts.
Check that the engine is stopped when
you release the parking brake and leave
the seat. (See "Interlock system" (Page
6-9) .)
2.
3.
4.
[1]
[2]
Electrical components
About the Electrical components
Warning
When servicing electrical components, be
sure to disconnect the negative battery cable.
Safety Switches
The following devices are used as safety
switches to prevent injuries and accidents due
to operator inattentiveness.
Related to engine starting and operation (See
"Interlock system" (Page 6-9) .)
Seat switch
Parking brake switch
Reel rotation switch
･
･
･
LM2700
Electrical system
Page 6-16 Electrical components