Baroness LM2700, Service Manual

Page: 136 / 325

Steering Cylinder
Removal of Steering Cylinder
Important
Take note of the installation position when
removing the hydraulic hose.
Remove 2 hydraulic hoses attached to the
steering cylinder.
2
1
h26hgv-005
Removal of Steering Cylinder_001
1 Hydraulic hose
2 Steering cylinder
Follow the steps below to remove the
steering cylinder.
Remove the cotter pin, washer and flat
head pin.
Remove the U nut and spring washer.
Remove the steering cylinder.
2
6
7
8
1
3
5
4
h26hgv-003
Removal of Steering Cylinder_002
1.
2.
[1]
[2]
[3]
1 Washer
2 Cotter pin
3 Cylinder
4 Spring washer
5 U nut
6 Pivot
7 Flat-head pin
8 Kingpin
Remove elbow from the steering cylinder.
1
2
h26hgv-004
Removal of Steering Cylinder_003
1 Steering cylinder
2 Elbow
Installation of Steering Cylinder
Caution
After the installation, check if there is no oil
leakage in each part.
Caution
See "Tightening torques" (Page 3-5) .
Note that the Baroness product warranty may
not apply to defects caused by incorrect or
overtorque tightening etc.
Important
Make sure of the installing locations of the
hydraulic hoses and do not install them at the
wrong locations.
For installation, reverse the removing
procedure.
3.
LM2700
Hydraulic system
Page 5-82 Removal and installation of each section