Installing The Bed Knife
Caution
Both the reel cutter (cutting cylinder) and the
bed knife (bottom blade) are edged tools.
Handle them carefully, since they could cut
your hands and feet.
Caution
Raising the front part of the machine for
servicing operation may create a falling
hazard.
Support the machine securely.
Caution
See the list in Tightening torques.
Note that the Baroness product warranty may
not apply to defects caused by incorrect or
overtorque tightening etc.
Important
Be sure not to scratch the bed knife base
surface where the bed knife shall be mounted.
Remove rust and dust.
Important
Replace the old screws with new ones.
Tighten the screws uniformly with a
hammer driver.
2
3
1
4miqko-001
Installing The Bed Knife_001
1
Bed knife base
2
Bed knife
3
Screw
1.
Note:
First, tighten the screw at the center. Then,
follow the numerical order, first to the right
and then to the left, as shown below.
1
2
4miqko-002
Installing The Bed Knife_002
1
Bed knife
2
Screw
Removing/Installing The Cover (Left)
Removing The Cover (Left)
Insert an item such as a wooden hammer
handle into the reel cutter to prevent the
reel cutter from turning, and remove the
special bolt.
3
2
1
xg9isz-001
Removing The Cover (Left)_001
1
Reel cutter
2
Special bolt
3
Wooden hammer
1.
Maintenance
LM18GB
・
LM56GB/LM66TB
Maintenance
Page 6-15
Maintenance (Mower)
