Baroness LM180C, Owner'S Operating Manual

Page: 53 / 66

Removing/Installing Tires
Front Tires
Follow the steps below to remove the front
tires:
Loosen the bolts.
lm2ieh-001
Front Tires_001
Place the tire jack beneath the jack-up point
of the front axle area securely, then raise it
until the tire lifts off the ground.
"Jack-up Points" (Page 5-5)
Remove the bolts.
Remove the tire from the wheel mounting
shaft.
Important
Tighten the bolts in the tightening order
(crosswise).
For installing the front tires, reverse the
removing procedure.
Rear Tires
Follow the steps below to remove the rear
tires:
Loosen the bolts.
upekw4-001
Rear Tires_001
1.
2.
3.
4.
1.
Place the tire jack beneath the jack-up point
of the rear wheel transmission area
securely, then raise it until the tire lifts off
the ground.
"Jack-up Points" (Page 5-5)
Remove the bolts.
Remove the tire from the wheel mounting
shaft.
Important
Tighten the bolts in the tightening order
(crosswise).
For installing the rear tires, reverse the
removing procedure.
Adjustment of Belt Tension
Warning
Be sure to stop the engine before adjusting
the belts.
Caution
If you have removed covers, etc., be sure to
securely install them in their original positions.
If covers, etc., remain removed, the operator
may come in contact with rotating parts or
belts, or foreign objects may fly off, possibly
resulting in injuries.
Important
For the specified value of belt tension, refer to
Adjusted Values.
After rotating the belt several times, check that
it has the specified tension.
If the belt becomes slack due to frequent use, it
may jump or slip.
In addition, if it is overtightened, it may wear
prematurely.
If necessary, adjust it, and always check the
belt for appropriate tension.
2.
3.
4.
Maintenance
LM180C
Maintenance
Page 5-13
Maintenance Work