Baroness LM180C, Owner'S Operating Manual

Page: 32 / 66

Adjustment of Cutting Height
Important
The front wheel is provided to prevent the reel
cutter (cutting cylinder) from damaging a
convex portion of the lawn surface.
Adjust the height so that the front wheel will
not be grounded but raised by 10-20mm off
the ground.
The cutting height is adjusted by moving the
roller up or down.
Refer to the cutting height scale plate to decide
the height.
To increase cutting height:
Loosen nut A, lower the roller, then tighten
nut B.
To decrease cutting height:
Loosen nut B, raise the roller, then tighten
nut A.
6
3
5
1
2
4
3kws2a-002
Adjustment of Cutting Height_001
1 Nut A
2 Nut B
3 Roller
4 Front wheel
5 Cutting height scale plate
6 Reel cutter (cutting cylinder)
Procedure to Start/Stop Engine
Start/Stop of Engine
Procedure to Start Engine
Caution
Before starting the engine, make sure that
there are no other people or obstacles around
the machine.
Sit on the seat.
1.
2.
1.
Make sure that the parking brake is applied.
Make sure that the traveling clutch lever is
set to the "OFF" position.
Make sure that the reel rotation lever is set
to the "Stop" position.
Make sure that the change lever is set to
the neutral position.
Set the fuel cock to the "Open" position.
The fuel cock is located under the fuel tank.
Shift the throttle lever from the "Low speed"
position halfway to the "High speed"
position.
Pull the choke knob.
Pull the knob half way for restarting, as
necessary.
Set the engine switch to the "ON" position.
Pull the starter grip swiftly, and the engine
will start.
Important
Return the starter grip slowly to its original
position after the engine starts.
Do not let go of the pulled starter grip since it
may cause damage to the machine.
Make sure that the engine has started, and
then slowly return the choke knob to its
original position.
Shift the throttle lever to the "Low speed"
position, and then warm up the engine for 1
to 2 minutes.
Gradually move the throttle lever to the
"High speed" position.
Procedure to Stop Engine
Depress the brake pedal.
Apply the parking brake.
Set the reel rotation lever to the "Stop"
position.
Shift the traveling clutch lever to the "OFF"
position.
Shift the change lever to the neutral
position.
Shift the throttle lever to the "Low speed"
position , and continue idling for 1 to 2
minutes.
Set the engine switch to the "OFF" position.
Make sure that the engine has stopped.
Set the fuel cock to the "Close" position.
The fuel cock is located under the fuel tank.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
1.
2.
3.
4.
5.
6.
7.
8.
9.
LM180C
Handling Instructions
Page 4-12
Procedure to Start/Stop Engine