Baroness LM180C, Owner'S Operating Manual

Page: 27 / 66

Important
During installation, prevent contamination with
dirt or dust.
If the fuel is contaminated with dirt, dust, etc.,
the fuel flow will become insufficient.
Correctly install all parts in their original
positions.
Fill up the fuel tank with fuel, and then open
the fuel cock.
Make sure that there is no fuel leakage.
Transmission
Inspection of Transmission Oil
Place the machine so that its frame will be
level, and then make sure that the
transmission oil level is at the oil level plug
at any time.
The oil level plug is located on the right side
of the transmission.
Check underneath the machine for oil
leakage.
3
2
1
4sr81t-001
Inspection of Transmission Oil_001
1 Oil filling port
2 Oil level plug
3 Drain plug
Filling of Transmission Oil
Important
Do not mix different types of transmission oil.
Important
Be sure to pour automobile gear oil that is
classified as SAE Viscosity Grade #90 into the
transmission.
Remove the oil filler cap.
5.
6.
7.
1.
2.
1.
Supply transmission oil through the oil filling
port.
3
2
1
4sr81t-001
Filling of Transmission Oil_001
1 Oil filling port
2 Oil level plug
3 Drain plug
Check the oil level again 10 to 20 minutes
after filling the oil.
Check underneath the machine for oil
leakage.
Oil Leakage
Inspection of Oil Leakage
After approximately 50 hours of operation,
some joints may be loosened and oil and
grease may leak.
Be sure to retighten the parts.
Check the bottom of the machine for oil and
grease leakage.
2.
3.
4.
Handling Instructions
LM180C
Handling Instructions
Page 4-7
Inspections