Baroness LM101, Owner'S Operating Manual, Page: 78 / 88

Tighten all the lock nuts after making the
necessary adjustments.
Note:
If there is a rubbing noise when rotating the
drum or the drum feels difficult to turn, the
brake shoes may be making contact with the
brake drum.
In such a case, adjust it again.
Adjustment of Engine Clutch Section
For centering adjustment of the engine clutch :
Centering adjustment of the engine clutch is
required after replacement of the engine or
clutch parts.
Adjust the engine clutch.
Adjust the clutch wire.
Adjust the clutch spring.
For clearance adjustment of the engine clutch :
Clearance adjustment of the engine clutch is
required after replacement of the clutch wire or
when the clutch slips.
Adjust the clutch wire.
Adjust the clutch spring.
Change of Air Cleaner
A contaminated air cleaner element may cause
malfunction of the engine.
To maximize the life of the engine, replace the
air cleaner element at the appropriate times.
The timing for replacing the air cleaner
element is described below.
Replace the air cleaner element in
accordance with the Maintenance
Schedule.
If it is significantly contaminated, replace
it, even if the hours of operation do not
exceed the specified time.
Replace the air cleaner element by following
the same steps as for cleaning the air
cleaner.
"Cleaning of Air Cleaner" (Page 4-4)
10.
1.
2.
3.
1.
2.
1.
[1]
[2]
2.
Replacement of Engine Oil
Caution
Be careful with hot oil, which could cause
burns if it contacts your skin.
Important
When you replace the engine oil, be sure to
drain it into a bowl and discard it in
accordance with local laws and regulations.
Important
Be sure to use engine oil that is classified as
API Service Grade SE or higher, with an SAE
Viscosity that is appropriate for the operating
environment (ambient temperature).
Important
Screw the oil level gauge firmly.
Replace the engine oil more frequently if the
engine oil is contaminated, and especially if
you use the machine in dusty areas or operate
the engine at high loads or in high
temperatures.
Move the machine onto a level surface, stop
the engine.
Remove the drain plug while the engine oil is
warm, and then drain the engine oil into a
bowl.
Replace the drain plug in the engine.
Remove the oil level gauge.
Through the oil filling port, supply new
engine oil.
The engine oil quantity is approximately 0.56
dm
3
(0.56 L).
1.
2.
3.
4.
5.
LM101
Maintenance
Page 5-26
Maintenance Work