Baroness LM101, Owner'S Operating Manual, Page: 37 / 88

Raise or lower the front roller with the roller
adjustment bracket to set the position of the
front roller so that there is no clearance with
the bottom of the head of the cutting height
setting screw on the cutting height gauge at
the tip position of the bed knife.
3
A
2
1
3kws2a-007
Adjustment of Front Roller_004
1 Bed knife
2 Cutting height setting screw
3 Cutting height gauge
A Cutting height
Follow the same steps to adjust the cutting
height on the opposite side.
Tighten the nuts securing the left and right
roller brackets, and fix them securely.
Bring the cutting height gauge into contact
with the front roller and rear roller at the left
and right ends of the mowing part again,
and check that it is at the desired cutting
height.
Adjustment of Groomer
Note:
Depending on the specifications, this function
may not be available.
Important
When using the front groomer, adjust it to suit
the conditions on the green.
Important
Set the groomer to a height of 0.0 mm (0.0 in)
or more above the ground.
Setting the front groomer deeper than the
ground surface may cause damage to the
groomer shaft.
4.
5.
6.
7.
Important
Setting the front groomer too deep applies too
much load to the engine and transmission
parts, and may cause malfunctions or
damage.
Important
When using the grooming brush, set it to the
same height as the cutting height.
If the height of the grooming brush is too low
the brush will wear faster.
Set the slide caliper to the required groomer
height, adjust the tip of the groomer setting
screw on the cutting height gauge, and then
securely lock it with a wing nut.
1
4
3
2
A
2qrq2r-002
Adjustment of Groomer_001
1 Vertical blade
2 Groomer setting screw
3 Cutting height gauge
4 Front roller
A Groomer height
Loosen the nut B securing the left side
groomer adjustment screw.
Loosen the left side high nut.
1
5 4
2
3
2qrq2r-007
Adjustment of Groomer_002
1.
2.
3.
Handling Instructions
LM101
Handling Instructions
Page 4-15
Adjustment before Work