Adjustment of Cutting Height
Adjustment of Rear Roller
The rear roller can be adjusted to one of four
settings.
Attach the rear roller within the cutting height
range at a position that suits your work
requirements.
Important
The installation orientation of the roller bracket
differs depending on the specified cutting
height.
For a cutting height between 5.0 and 14.0
mm, install the roller bracket in the
orientation for low cutting.
For a cutting height between 7.0 and 20.0
mm, install the roller bracket in the
orientation for high cutting.
1
A
B
A
B
2
3kws2a-026
Adjustment of Rear Roller_001
1
Low cutting
2
High cutting
A
Long
B
Short
Important
The figure below shows the bolt positions for
the installation holes in the roller bracket and
frame.
Be sure to install the bolts in the correct
installation holes.
･
･
2
1
A B
C
D
3kws2a-027
Adjustment of Rear Roller_002
1
Frame
2
Roller bracket
A
5.0 - 10.0 mm (0.197 - 0.394 in)
B
5.0 - 14.0 mm (0.197 - 0.551 in)
C
7.0 - 16.0 mm (0.276 - 0.630 in)
D
12.0 - 20.0 mm (0.472 - 0.787 in)
Note:
Comparing settings A and B at the same
cutting height, the offset distance of B is
longer than A.
The offset distance is the distance from the
center of the reel cutter (cutting cylinder) to
the tip of the bed knife (bottom blade) in the
horizontal direction.
B
A
1
2
3kws2a-030
Adjustment of Rear Roller_003
1
Reel cutter (Cutting cylinder)
2
Bed knife (bottom blade)
A
Cutting height
B
Offset distance
The same goes for settings B and C and
settings C and D.
If the roller bracket is not installed for the
desired cutting height, follow the steps below
to install the rear roller.
Remove the rear roller.
1.
LH52
Handling Instructions
Page 4-8
Adjustment Before Operating
