Baroness LH52, Owner'S Operating Manual

Page: 17 / 43

Roller
Inspection of Rollers
Bearing wear due to frequent use or bearing
damage caused by water infiltration may
prevent the roller from rotating smoothly.
Inspect the roller and, if necessary, replace
parts such as oil seals and bearings.
Make sure that there is no abrasion nor
adhesion of the roller.
Make sure that there is no wear of the roller
shaft.
Make sure that there is no wear nor
damage of the oil seal.
Make sure that there is no wear nor rust of
the bearing.
Make sure that there is no play in the roller
shaft.
Inspection of Support Roller
Note:
Depending on the specifications, this function
may not be available.
Wear of bearings due to frequent use and/or
damage of bearings, etc. caused by invasion
of water may prevent the roller from rotating
smoothly.
Inspect the roller and, if necessary, replace
parts such as bearings.
Make sure that there is no abrasion nor
adhesion of the roller.
Make sure that there is no wear of the roller
shaft.
Make sure that there is no wear nor rust of
the bearings.
Make sure that there is no play in the roller
shaft.
1.
2.
3.
4.
5.
1.
2.
3.
4.
Groomer
Inspection of Groomer
Note:
Depending on the specifications, this function
may not be available.
The operating efficiency may be reduced due
to frequent use, objects crushed during
operation, or damage to blades or the shaft
during transportation.
In addition, bearing wear or bearing damage
caused by water infiltration may prevent the
shaft from rotating smoothly.
Inspect the groomer and, if necessary,
replace parts such as blades or bearings.
Make sure that the blades are not cracked.
Check how much the blades are worn.
Make sure that the shaft is not worn nor
bent.
Make sure that there is no wear nor rust of
the bearing.
Make sure that there is no play in the
groomer shaft.
CR brush
Inspection of CR Brush
Note:
Depending on the specifications, this function
may not be available.
Bearing wear due to frequent use or bearing
damage caused by water infiltration may
prevent the brush from rotating smoothly.
Inspect the brush and, if necessary, replace
parts such as bearings.
Make sure that there is no abrasion nor
adhesion of the brush.
Make sure that there is no wear of the
brush shaft.
Make sure that there is no abnormality in
the brush.
Make sure that there is no play in the fit of
the bearing and the housing.
Make sure that there is no play in the brush
shaft.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
Handling Instructions
LH52
Handling Instructions
Page 4-3
Inspection Before Use