Baroness GM2810, Service Manual

Page: 91 / 185

Parking Brake Switch
The parking brake is equipped with a parking
brake switch, one part of the interlock system.
The switch contact point is activated through
the operation of the brake pedal, controlling
starting and stopping of the engine.
1
2
3
4
5
67xzzh-001
Parking Brake Switch_001
1 Brake pedal
2 Switch contact point
3 Adjusting nut A
4 Adjusting nut B
5 Parking brake switch
Link the left and right brake pedals, and then
pull up the parking brake lever to apply the
parking brake. (See "RT mechanical brake
manual" (Page 9-13) .)
1
2
67xzzh-002
Parking Brake Switch_002
1 Notch
2 Parking brake stopper
1.
Important
After adjusting the foot brake wire, check that
the machine is firmly stopped with the parking
brake at notch 5 - 6. (See "Adjusted Value of
the Foot Brake Wire" (Page 6-3) .)
With the parking brake at notch 5, adjust
adjusting nut A and adjusting nut B of the
parking brake switch to create a slight
clearance at the switch contact point.
1 2 3
67xzzh-003
Parking Brake Switch_003
1 Switch contact point
2 Adjusting nut A
3 Adjusting nut B
Important
If the switch contact point is pressed more
than a stroke of the switch, the switch may be
damaged.
Release the parking brake, and then make
sure that the switch contact point is pressed.
Follow the steps below to check the
operation of the parking brake switch.
While sitting on the seat with the parking
brake set to at least notch 5 and the rotary
knife switch set to the "OFF" position,
check that the engine starts.
Check that the engine is stopped when
you release the parking brake and leave
the seat. (See "Interlock System" (Page
5-7) .)
2.
3.
4.
[1]
[2]
Electrical system
GM2810
Electrical system
Page 5-9
Adjustment