Baroness GM1700, Service Manual, Page: 114 / 192

Straighten the front wheels and then
measure the front width A and the rear
width B between the front wheels.
Loosen the left and right lock nuts, and then
rotate the tie rod to make adjustment.
Target adjustment value of the toe angle is
0±5.0 mm (0±0.20 in). (Toe angle amount =
A
– B)
1
2
FRONT
1
ufr7l4-003
Adjustment of Toe Angle_002
1 Lock nut
2 Tie rod
2.
3.
Inspection and repair of each section
Brake
A worn brake shoe will increase the amount of
brake pedal depression, and may cause the
pedal to touch the floor or result in uneven
braking. Inspect the brake accordingly.
Adjust the brake shoe clearance to be even on
both sides. A brake shoe is gradually worn
down like an eraser as the brake is applied.
Check the remaining shoe amount upon
inspection and replace as needed.
Inspection of Brake
Adjust the clearance of the brake shoe so that
the left and right sides are even. Brake shoe
wears out gradually as the brake is used just
like an eraser. Check the remaining amount at
the inspection. Replace if it is too small.
Disassembling and Assembling the Brake
The brake shoe can be replaced while the
brake is installed to the machine.
a1y6z3-001
Disassembling and Assembling the Brake_001
1 Shoe
Remove the upper and lower springs.
The sizes of the upper and lower springs
are different with each other.
1
1
a1y6z3-002
Disassembling and Assembling the Brake_002
1.
GM1700
Main body
Page 6-10
Inspection and repair of each section