Baroness GM1700, Owner'S Operating Manual

Page: 73 / 87

If the front tires rotate in reverse, loosen
lock nuts B and C of the threaded rod,
then turn the threaded rod to extend the
connection.
Find the position where the front wheels
stop, and then tighten lock nuts B and C.
5
6 7
1
4
3
2
hsn2jo-020
Adjusting the Neutral Position of the Piston Pump_002
1 Cam lever
2 Cam lever shaft
3 Shaft seat
4 Lock nut A
5 Threaded rod
6 Lock nut B (right-hand screw)
7 Lock nut C (left-hand screw)
Change of Coolant
Caution
Do not touch the radiator or coolant during
engine operation or immediately after the
engine has been turned off.
Otherwise, you may get burned.
Caution
Change coolant after the engine has well
cooled down.
Caution
The radiator cap is pressurized.
If you remove the radiator cap while the
engine is overheated, hot steam will burst out,
possibly resulting in burns.
Make sure that the water temperature and
pressure are reduced, and then grab the cap
with a thick cloth and gradually open the cap.
[2]
Important
When changing the coolant, be sure to drain it
into a container and discard it in accordance
with local laws and regulations.
Important
When changing the coolant, be sure to mix
clean water and antifreeze (long-life coolant),
and then pour it into the radiator and reserve
tank.
Important
Tightly close the radiator cap.
If the cap is loose or incorrectly installed, the
engine will be overheated due to water
leakage, resulting in engine damage.
When mixing antifreeze and clean water, refer
to "Relationship between concentration of long-
life coolant (LLC) and freezing temperature"
below for the mixing ratio.
Relationship between concentration of long-life
coolant (LLC) and freezing temperature
Freezing temperature
LLC concentration
(volume %)
Down to -10 °C (14 °F) 20 %
Down to -15 °C (5 °F) 30 %
Down to -20 °C (-4 °F) 35 %
Down to -25 °C (-13 °F) 40 %
Stop the engine, and then allow the radiator
to cool.
Open the hood.
Follow the steps below to drain the coolant.
Position a container to drain the coolant
into.
Remove the drain plug from the radiator.
1
v2x572-008
Change of Coolant_001
1.
2.
3.
[1]
[2]
Maintenance
GM1700
Maintenance
Page 5-15
Maintenance Work