Baroness GM1700, Owner'S Operating Manual

Page: 69 / 87

Rear Tire
Follow the steps below to remove the rear
tires:
Loosen the bolts.
1
upekw4-002
Rear Tire_001
1 Heat-treated bolt
Securely place the jack beneath the jack-up
point of the rear frame area, and then raise
it until the tire lifts off the ground.
"Jack-Up Points" (Page 5-5)
Remove the bolts.
Remove the tire from the wheel mounting
seat.
Important
Tighten the bolts in the tightening order
(diagonally).
For installing the rear tires, reverse the
removing procedure.
Adjustment of Belt Tension
Warning
Be sure to stop the engine before adjusting
the belts.
Important
Before making sure of belt tension, rotate the
belt several times.
If the belt becomes slack due to frequent use, it
may jump or slip.
In addition, if it is overtightened, it may wear
prematurely.
If necessary, adjust it, and always check the
belt for appropriate tension.
1.
2.
3.
4.
Fan Belt
Press the middle of the belt with your finger
to check the belt tension.
The belt tension is appropriate when the
belt slacks by approximately 10.0 mm (0.39
in) when you apply a force of 98 N (10 kgf)
to the belt at the middle point between the
pulleys.
If the belt tension is incorrect, loosen bolt A
and bolt B (securing the alternator), and
then move the alternator to adjust the
tension.
2
5
3
4
1
A
mzdn8n-004
Fan Belt_001
1 Fan Belt
2 Blade
3 Alternator
4 Bolt A
5 Bolt B
A 10 mm (0.39 in)
Knife Tension Belt
Remove the rear cover.
Set the knife rotation lever to the "Rotation"
and "Stop" positions, and check the
following points.
The tension lever operates correctly.
The spring stretches appropriately.
1
3
2
jsy6z7-001
Knife Tension Belt_001
1.
2.
1.
2.
･
･
Maintenance
GM1700
Maintenance
Page 5-11
Maintenance Work