Baroness FS900, Service Manual, Page: 85 / 163

Forward/reverse pedal proximity switch NC
Inspection of Control Output
Caution
Do not short-circuit the battery terminals.
Follow the steps below to connect the
battery and a tester to the connector
terminal of the forward/reverse pedal
proximity switch NC.
Connect the battery (+) to the connector
terminal (+), and the battery (-) to the
connector terminal (-).
Connect the tester (+) to the connector
terminal Vout (+), and the tester (-) to the
connector terminal (-).
Normal operation is that there is continuity
between connector terminals 2 and 3 when
the plastic magnet is getting away to the
proximity switch and there is no continuity
between connector terminals 2 and 3 when
the plastic magnetic is getting close from
the proximity switch.
-
+
-
+
1 2 3
6it54e-003
Inspection of Control Output_001
1.
[1]
[2]
2.
1 Connector terminal (+)
2 Connector terminal Vout (+)
3 Connector terminal (-)
Electrical system
FS900
Electrical system
Page 5-11
Electrical components