Baroness FS900, Service Manual, Page: 129 / 163

Removal and installation of each
section
Bucket
Removing the Bucket
Move the machine to level ground, then
apply the parking brake.
Lower the operating machine.
Stop the engine.
Remove the cylinder mounting pins, and
remove the bucket lid cylinder.
1
3
2
yi8si6-001
Removing the Bucket_001
1 Cylinder
2 Mounting pin
3 Bucket lid
Remove the bolt and spring washer, and
then remove the harness clip.
Remove the nylon band.
1
2,3
4
yi8si6-002
Removing the Bucket_002
1 Harness clip
2 Bolt
3 Spring washer
4 Nylon band
1.
2.
3.
4.
5.
6.
Remove the bucket lid open/close kit from
the machine, and place the kit as shown in
the figure.
1
yi8si6-003
Removing the Bucket_003
1 Bucket lid open/close kit
Remove the nylon band that holds the
sensor wire.
Remove the bullet connector for sensor
input.
1
2
3
yi8si6-004
Removing the Bucket_004
1 Nylon band
2 Sensor wire
3 Bullet connector for sensor input
Remove the nylon band that holds the
sensor wire.
7.
8.
9.
10.
Operating Machine and Mower Units
FS900
Operating Machine and Mower Units
Page 7-11
Removal and installation of each section