Dimensions
30.5 cm W x 46.7 cm W x 46 cm H.
Feedwater Requirements*
Max. Temperature:
48.8°C
Min. Pressure (standard unit):
30 psig (2.1 bar)
Min. Pressure (low pressure unit): 9 psig (0.62 bar)
Max. Pressure (standard unit):
100 psig (6.8 bar)
Max. Pressure (low pressure unit): 15 psig (1.1 bar)
Inlet Flow Requirements:
53.5 lph
pH:
4 - 11
TDS (Max. ppm as CaCO3):
500
Silt Density Index:
<5%
Free Chlorine:
<0.1 ppm*
Langlier Saturation Index:
Negative
Turbidity:
<1 NTU
Iron (Total as Fe):
<0.5 ppm
Product Water Specifications*
Product Water Flow Rate:
12 lph*
% Recovery:
20%-26%
Membrane Rejection Rates*
Monovalent Ions:
90-95%
Polyvalent Ions:
95-99%
Particles:
>99%
Microorganisms:
>99%
Dissolved Organics (300 MW):
>99%
Reject Water Flow Rate:
650 ml/min
at 60 PSIG
±5 PSIG
5
General Specifications
* Notes:
1 Feedwater suitability must be determined by a water analysis.
2 Free chlorine removed by pretreatment cartridge.
3 ±1.5 lph, feedwater at 25°C and 60 psig pressure.
4 Membrane performance is dependent on condition, pressure, recovery, water temperature and water com
position. Listed membrane performance for a new membrane is based on optimum operating conditions of
60 psig, 15% recovery, 25°C (77°F) feedwater temperature and feedwater composition of a maximum of
500 ppm NaCl at a pH of 6.0-6.5.
5 Membrane performance, flowrates and recovery information are nominal values. Variations in the
feedwater temperature, pumps and reject orifice may slightly alter these results.
