10
Wall Mounting
Install the wall bracket on the wall in a location that is ac-
cessible to water and convenient to use. A minimum of 4
fasteners must be used.
1.
Remove the pump interlock plug from the rear of the
unit.
2.
Open cartridge access door in the rear of the unit.
3.
Remove the cover of the EASYpure LF by removing
the screws that secure it to the unit and lifting it
straight up.
4.
Remove tubing attached to quick disconnect body.
5.
Remove the inlet quick disconnect body from the rear
of the EASYpure LF cabinet.
6.
On both sides of the wall bracket there are plugs. Re-
move the plug from the side that is most accessible to
your feedwater source. Install the inlet quick discon-
nect body fitting into the hole by placing the inlet quick
disconnect into the hole and secure in place with the
locknut inside. Replace the plug in the hole generated
in the EASYpure LF (where the disconnect body was
installed).
7.
Remove the four feet from the EASYpure LF and
retain the screws.
8.
Place the EASYpure LF on the wall bracket swivel
base so the screw holes where the feet were attached
line up with the holes in the wall bracket. There are
guides on the wall bracket that will mate with the
EASYpure LF.
WARNING
Do not locate the EASYpure LF directly over
equipment that requires electrical service. Rou-
tine maintenance of this unit may involve water
spillage and subsequent electrical shock hazard
if improperly located.
CAUTION
Wall composition, condition and construction, as
well as fastener type, must be considered when
mounting this unit. The mounting surface and
fasteners selected must be capable of support-
ing a minimum of 150 lbs. Inadequate support
and/or fasteners may result in damage to
mounting surface and/or equipment. If you are
unsure of mounting surface composition, condi-
tion and construction or correct fasteners, con-
sult your building maintenance group or con-
tractor.
Wall Mounting
