BARKO LOADERS 295, Service Manual

Page: 43 / 85

page 43
295 AC
800-00158
DANFOSS DRIVE MOTOR MAINTENANCE (OMV800)
General Instructions
To facilitate the repair of these units and before any
work is done, we suggest that you first read all of the
steps used in disassembly and assembly.
Dirt is the enemy of any hydraulic system. The first
requirement for good maintenance of hydraulic
equipment is cleanliness. MAKE SURE YOU
DISASSEMBLE AND ASSEMBLE YOUR
HYDRAULIC EQUIPMENT IN A CLEAN AREA.
It is important to airblast all parts and wipe them with
a clean, lintless cloth before assembly.
USE CAUTION IN GRIPPING ALL PARTS
IN A VISE TO AVOID DAMAGING
MACHINED SURFACES.
TORQUES:
Item 1:265 - 355 In. Lbs.
Item 10:
265 - 530 In. Lbs.
Item 41: 1680 - 1860 In. Lbs.
040204
1. SCREW
2. DUST SEAL RING
3. FRONT COVER
4. SHAFT SEAL
5. O-RING
8. SEAL RING, conical
9. BEARING HOUSING
10. DRAIN PLUG
13. CARDAN SHAFT
21. SHAFT, splined
22. O-RING
23. GEAR WHEEL SET
24. GUIDE PIN
25. VALVE DRIVE
26. CHANNEL PLATE
27. STOP RING
28. DISC VALVE
29. BALANCE PLATE
30. GUIDE PIN
31. O-RING
32. O-RING
33. SPACER
34. SPRING WASHER
35. SEAL PLUG
36. VALVE HOUSING
37. BALL
38. SPRING
39. WASHER
40. PLUG
41. SCREW
42. NAME PLATE