BARKO LOADERS 295, Service Manual

Page: 19 / 85

page 19
295 AC
800-00158
8 hours
Daily
SERVICE REQUIRED
Fan and Drivebelts - Check for looseness
and wear. Tighten or replace as needed.
Operator's Platform - Clean area of debris,
tools, rags, water, ice, and snow.
Fuel Tank - Check level and fill if necessary.
Engine Crankcase Oil - Check level.
Engine Radiator - Check coolant level and
fill if necessary. Inspect exterior for dirt and
debris and clean if necessary.
Hoses, Connections, Cylinders - Inspect for
leaks and damage. Tighten, repair, or
replace parts if necessary.
Pump Drive - Check fluid level.
Swing Motor Gearbox - Check fluid level.
Engine Air Cleaner - Inspect & replace
element,if needed.
Hydraulic Reservoir - check level and quality
of oil.
Hydraulic Oil Reservoir - On new machines
the oil must be changed after the first 50 hours,
and then every 1000 hours after that.
Hydraulic Oil Filter - On new machines the
filter element should be replaced first at 50
hrs. and then at 400 hrs. thereafter.
Engine Shrouding - Clean and inspect.
SERVICE SCHEDULE
Fittings - Lubricate as shown on Lubrication
Points. Use a multi-purpose grease.
Bolts/Nuts - Visually inspect for wear or
damage.
Control Lever Linkage - Lubricate.
Bolts/Nuts - Check for proper
torque every 50 hours. Retorque if necessary.
Battery - Clean and coat posts with grease.
Check electrolyte level and fill if necessary.
Engine Oil Filter - Replace.
Hydraulic Oil Cooler and Radiator - Clean.
Hydraulic Oil Reservoir Breather - Replace.
Hydraulic Collector - Check mounting bolts.
Accumulators - Check pressure and maintain
at 900 PSI.
50 hours
Weekly
100 hours
Monthly
400 hours
2 Months
1000 hours
6 Months
Yearly
Swing Motor Gearbox - On new machines
the fluid should be changed first at 50
hrs. and then every 400 hours thereafter.