4
• CO
2
CARTRIDGE
• DO NOT
attempt to remove a cartridge if it is
not empty.
• NOTE:
Ensure that the pressure control
valve is set to fully closed before attempting
removal or replacement of a gas cylinder.
• NOTE:
The cartridge mount has an ‘O’ ring
seal. If the seal is proven to be leaking,
replacement ‘O’ rings are supplied in the kit.
• NOTE:
The cartridge used on this unit is
NOT
the threaded type.
• Open the unit lid by pressing the button on the
lid (fig.1).
• Unscrew the CO
2
bottle housing from its
location within the lid and remove empty
cartridge from the unit (fig.2).
• Check that the ‘O’ ring seal is in situ and in
good condition. Replace seal if in doubt.
• Place new cylinder into housing and relocate
into head.
• CARTRIDGE PIERCING CARE
• The cartridges used in this unit are of the blind
type i.e. they are NOT threaded. As such they
require piercing in order to operate.
•
Should the piercing tool need replacement,
remove the empty gas cartridge.
• Carefully remove the ‘O’ ring seal from the
cartridge nest and lift out the installed piercing
tool (fig.3).
• Insert the replacement piercing tool and ‘O’
ring noting that the orientation of the piercing
point is towards an inserted gas cartridge.
• BEER DISPENSING UNIT
• Assemble the dispensing unit by locating the
peg on the main body into the notch in the
clamp frame (fig.4) NOTE: It can only fit in one
direction.
•
Screw the delivery tube onto the dispensing
unit making sure that the ‘O’ ring seal is in situ
and in good condition. Replace seal if in doubt.
• CONNECT DISPENSER TO TAP
•
Assemble clear hose and connector as fig.5.
• Lift the lid of the unit and press the release
mechanism on the tap body to release the
centre section of the tap body (fig.5).
• Place the clear hose through the hole in the
removable centre section and while pushing
the tap handle down in the open position,
thread the clear hose down into the tap body.
CO
2
Cartridge housing
Pierce tool and ‘O’ ring
Fig.2
Fig.3
Fig.4
