56-101-01178 Revision K
Page | 25
B. Display Setup
– Configuring display format
The Display Setup allows the user to configure the display as a 2 or 4-parameter format.
While operating in Aeronautical mode for example, the 4-parameter format will allow ALT,
ROC, CAS and MACH or ALT, ROC, CAS, and RtCAS to be displayed. While in Control
mode, Target values can be assigned to ALL 4 parameters by simply touching the screen
on each of the 2 or 4-parameter displayed areas.
Figure 25
Display Setup: 4-Parameter
Figure 26
Display Setup
:
2-Parameter formats
C. Units
– Displayed units
Once the Display Setup has been selected, (Aeronautical, Pressure units or EPR, 4-
parameter or 2-parameter display format) the Units menu choices allow the user to select
the units of measure for the given display parameters selected.
For example, for Aeronautical mode the available units for ALT is (1) ft or (2) m, depending
on which is selected the corresponding units for ROC (1) ft/min or (2) m/min and for CAS (1)
kts or (2) km/h and for RtCAS (1) kts/min or (2) km/h/min. Regarding MACH, it is a
dimensionless quantity and is always displayed as MACH.