![background image](http://html.mh-extra.com/html/barco/xdx/xdx_installation-manual_474403044.webp)
R5914481 /02 XDX
44
W2
U1
U2
V1
V2
W1
A
B
C
D
Image 4–5 Δ configuration
3.
Mono phase configuration
: Spread the four links over the six pins as illustrated. Make sure both the
upper and lower pins are connected with each other.
W2
U1
U2
V1
V2
W1
A
C
B
D
Image 4–6 Mono phase configuration
4.
Turn a nut on each pin and secure with a torque wrench set to
3.5 Nm
.
4.3 Connecting the projector with the power net
WARNING:
The total electrical installation should be protected by an appropriate rated and readily
accessible disconnect switch, circuit breakers and ground fault current interrupters. The installation
shall be done according to the local electrical installation codes.
CAUTION:
ALL POWER CONNECTIONS to the XDX projector are made to the five-terminal strip
located on the mains board behind the operator side cover and mains cover of the projector.
CAUTION:
The cross-sectional area of the conductors in the Power Supply Cord shall be not less
than 4 mm
2
or AWG 10.
Required tools
•
Flat screwdriver
•
Open-end wrench 36 mm
•
Torx screwdriver T20
Required parts
•
Certified AC power supply cord 4 mm², 10 AWG, min. 300 V (in case of mono phase or Δ configuration)
•
Certified AC power supply cord 4 mm², 10 AWG, min. 500 V (in case of Y configuration)
Summary of Contents for XDX
