Barco XDL-4K30, User Manual

Page: 101 / 164

R5906151 /02 XDL 101
Image 8-65
8.8.5 3D emitter Setup
Why change the 3D setup?
While Barco can provide a 3D emitter and active shutter glasses as options to this projector, you are also free
to use a 3D emitter and active shutter glasses of your own choice. Since glasses and emitter can have various
specifications compared to the ones Barco can provide, the 3D setup menu allows you to configure the output
image to the specifications of your glasses and emitter. The following can be configured:
• Swap Eye : You can choose to invert the stereo Sync output signal ( depending on the chosen 3D emitter
and glasses).
• Swap frame pair : You can choose to invert the stereo input signal (depending on the chosen source
input).
• Dark time : You can select how much dark time the projected image will have between frames. You can
choose one of the options between 1000 µs and 2500 µs.
• Stereo glasses : You can select the desired type of 3D glasses. You can choose between Active 3D
glasses, or 6P Laser Glasses.
• Sync Delay : You can increase or decrease the sync delay. The scale goes from – 10 000 µs to +10 000 µs
with a step of 100 µs.
If a 3D emitter is used that radiates infrared beams (IR beams), the IR beams may interfere with the
IR communication between projector and the RCU. If such interference occurs, connect the RCU to
the projector using the remote cable. It is also advised to turn the IR receivers on the projector off to
avoid the 3D emitter interference. To turn off the IR receivers, see
“ Remote control, on/off button ” ,
page 23.
How to adjust the projector to the 3D emitter?
1. In the main menu, select Installation → 3D Setup .
Image 8-66: Installation menu, 3D setup
The 3D setup menu is displayed
GUI – Installation