Barco X Series, Installation Manual

Page: 22 / 84

4. Components of the X-series display
4.2 X-series truss setup accessories
Truss setup accessories
X-series truss beams are required to set up an X-series display in a hanging con fi guration. Barco offers three sizes of X-series truss
beams, namely the dual (2x), triple (3x) and quad (4x) truss beam. These truss beams cover a width of respectively two, three and
four X-series tiles. Each truss beam is equipped with two or more lifting eyes.
In order to build the X-series display, the tiles must be connected using connection pieces. Four types of standard connection pieces
are available as well as four types of advanced (rental) connection pieces(see also "Overview of standard connection piece types",
page 22 and "Overview of advanced (rental) connection piece types", page 23).
1
2
3
4
Image 4-7
1
X-series dual truss/ fl oor beam.
2 X-series triple truss/ fl oor beam.
3 X-series quad truss/ fl oor beam.
4 X-series connection pieces.
W
ARNING
:
Maximum weight limit of the triple truss/ fl oor beam is 312 kg and the quad truss/ fl oor beam can
maximum lift 416 kg. This weight corresponds with a maximum display height of 16 tiles X-series tiles. Do
not put any additional weight on the truss/
fl oor beam and use the truss/ fl oor beams only in conjunction with
Barco’s X-series tiles.
W
ARNING
:
Always secure all truss/ fl oor beams of a hanging X-series display with the truss installation. The
safety cable has to be placed through the inner frame of the truss/ fl oor beam. Secure each truss with an
independent safety cable.
18 R5906024 X-SERIES 15/03/2016