Barco VRWF-3200, System Installation Manual

Page: 43 / 71

8. Setup
Setting Default value Note
Mode Master in VR Workroom see note below on Mono in VR Workroom
Mode
Computer Name
VRslave can be adapted to meet local LAN policies
Master as Slave source L3 DVI can be different if input hardware
configuration is changed
Baud rate 115200 Must be same as the value set in the slave
projector. See “Projector communications
settings” below.
RS 232 address
2 Must be same as the value set in the slave
projector. See “Projector communications
settings” below.
For the Slave :
Setting Default value
Note
Mode Slave in VR Workroom see note below on Mono in VR Workroom
Mode
C
AUTION
:
Never change these settings ! Changing these settings will not guarantee proper functioning of
the VR Workroom system.
Note : Mono in VR Workroom mode
In the
Mono in VR Workroom
mode both projectors are switched on but only one projector is projecting an image.
The projector projecting the image is selected based on the projector’s lamp runtime (the shortest lamp runtime is selected).
In fact the other projector is powered up i.e. all the electronics are powered up except for the lamps (this is
necessary to allow VR Workroom functionality).
How to check the settings ?
1. On the master projector, Go to
Start/Control Panel
2. Select
Appearance and themes/Barco Desktop integration
A dialog box is displayed
3. Open the
Mode
tab
8.1.2 iCon Server settings
iCon server settings
To allow communication between the master and the slave projector both servers have to be ON, even if the projectors are in the
Standby state :
Setting Default value Note
Projector Standby state ON Must always be ON !
Projector ON state ON Must always be ON !
How to access the iCon Server settings ?
1. Press
MENU
to activate the Tool bar
2. Press → to select
Installation
3. Press ↓ to Pull down the menu
4. Use ↑ or ↓ to select
iCon Server settings
(image 8-3)
5. Press
ENTER
R5976989 BARCO VR WORKROOM 22/09/2006 37