Barco ULTRA REALITY 7000 R9002810, Owner'S Manual

Page: 70 / 99

10. Image files menu
Image 10-2
In PiP mode, the files which may be loaded will be of the data type if the active window is a data window, or
they will be of the video type if the active window is a video window.
What to do if the image is not perfect ?
If the displayed image is not correct after AutoImage or after selecting the best fitting file, go to the Edit menu, select the active file
and change the settings.
10.2 Auto Image
What can be done ?
Auto Image creates the best suited image file for the connected source.
It calculates/measures several source parameters :
• Total pixels per line
• Start pixel
• Phase
• Contrast/Brightness levels
Auto Image works only for data images.
The measure of the total number of pixels per line can be done through 2 methods
• Limited scan: a windowing is used to allow fast tracking.
The operation takes about 20 seconds (depending on file)
• Full scan: tracking is done over the full range.
The operation takes about 1.5 minutes (depending on file)
How to launch Auto Image?
1. Press MENU to activate the Toolbar
2. Press → to select the
Image files
item
3. Press ↓ to Pull down the
Image files
menu
4. Use ↑ or ↓ to select
Auto Image
5. Press → to open the menu
6. Use ↑ or ↓ to select the desired file scan method (image 10-3)
7. Press ENTER
A textbox showing a progress bar is displayed. (image 10-4)
Tip: Press the Cancel button to cancel the operation.
66 R5976455 BARCO ULTRA REALITY 7000 30062003