Barco UDX, Installation Manual

Page: 94 / 150

R5906113 /08 UDX 94
9.1 Power on projector
How to power on
1. Press the mains switch at the side of the projector to switch on this projector.
Image 9-1: Mains switch
• When '0' is pressed, the projector is switched off.
• When 'I' is pressed, the projector is switched on.
The projector starts up to standby mode. The Power on/off button will blink until standby mode is achieved.
Once in standby mode, the Power on/off button will be lit WHITE, but the display will be off.
2. Press the Power on/off button on the projector, or the Power On button on the remote control.
The projector will continue to power on mode. The Power on/off button will blink until the projector is ready.
Once the projector is ready, the Power button will be lit BLUE.
The start up screen is displayed on the touch panel and when fully started up, it changes to the overview
screen.
1
2
Image 9-2
The current mains input voltage is indicated on the voltmeter just above the power switch.
The background image of the startup screen and info screens can be changed with Projector
Toolset with an installed UDX plug-in.
Status overview
Once the projector is started, press Status to get an overview of parameters such as :
• Device serial number and article number
• Current firmware version and model name
• Current illumination (in percentage)
• Projector runtime in hours
• Uptime in hours
Getting Started