Barco UDM, Installation Manual, Page: 48 / 106

R5911438 /09 UDM 48
4.2 Connecting the projector with the power net
CAUTION: Use only the power cord provided with the projector.
WARNING: Do not attempt operation if the AC supply and cord are not within the specified voltage
and power range.
CAUTION: If the input voltage exceeds a defined limit, the “Overvoltage” will light up as an warning.
Do NOT turn the power switch to “ON” when this occurs. .
How to connect with local power net
1. Ensure that the power switch (reference 1) stands in the '0' (OFF) position.
2. Connect the female side of the power cord with the power input socket of the projector.
1
Image 4–4
3. Connect the male side of the power cord to the local power net.
4. If “Overvoltage” lights up when connecting the powercord, do NOT press the power switch to on.
Pull out the powercord and check the mains voltage.
5. If “Overvoltage” is not lit, switch the projector ON by pressing power switch to the “I” (ON) position.
CAUTION: Once the projector is switched to standby, the cooling fans will continue to run for
approximately 30 seconds to ensure that the projector and light source have sufficiently cooled, at
which point the fans will automatically decrease to standby. To avoid thermal stress that can lead to
premature light source failure, never unplug the power cord while the cooling fans are running.
Never unplug the power cord to power down the projector, first switch off the power switch and then
unplug the power cord.
Installation procedures