Barco UDM, Installation Manual

Page: 24 / 106

R5911438 /09 UDM 24
2.1 Preparation process
Prepare for installation
1. Ensure that you understand all safety topics described in the chapter “Safety information”, page 7 .
2. Check if all installation requirements are fulfilled such as:
•
the environmental conditions of the installation area,
• the electrical facilities,
• cooling requirements,
• the capabilities of the supporting structure (table/ceiling)
• etc ... for more info see chapter “Installation requirements”, page 30 .
3. Unpack the projector or pull out the projector from its flight case. See chapter “Unpacking the projector”,
page 32 or see chapter “Flight case”, page 78 .
4. In case of a first install perform an initial inspection of the projector. See chapter “Initial inspection”.
5. Define the installation position of the projector. For detailed info and possibilities see chapters:
•
“Projector orientations”, page 35 .
• “Projector positioning”, page 37 .
• “Projector shift and tilt range”, page 38 .
6. Select the lens that will best fit for the application. See chapter “Lens selection”, page 40 , and “Available
lenses”, page 41 .
Installation process