Barco UDM Series, User Manual

Page: 26 / 190

R5911443 /02 UDM 26
The RCU will not function properly if strong light strikes the IR sensor window or if there are obstacles
between the RCU and the IR sensor.
45° 45° 45° 45° 45° 45°
Image 2-5
For detailed info about the RCU see chapter “ Pulse Remote Control Unit ” , page 31.
2.2 Power on the projector
How to power on
1. Does the OVERVOLTAGE status light (reference 1) lit up?
► If yes, pull out the power cord immediately. Contact a qualified technician to check the power net.
Warning: Never switch on the projector if the OVERVOLTAGE status light lit up. Neglecting will cause
irreversible damage to the projector.
► If no, proceed with the next step.
2. Press the mains switch (reference 2) to switch on this projector.
2
1
OVERVOL
TAGE
Image 2-6
• When '0' is pressed, the projector is switched off.
• When 'I' is pressed, the projector is switched on.
The projector starts up to standby mode. The Power on/off button will blink until standby mode is achieved.
Once in standby mode, the Power on/off button will be lit WHITE, but the display will be off.
Image 2-7
3. Press the Power on/off button on the projector, or the Power On button on the remote control.
The projector will continue to power on mode. The Power on/off button will blink until the projector is ready.
Once the projector is ready, the Power button will be lit BLUE.
Getting Started