6. Advanced configuration
Barco – TransForm A - Workstation for Windows – DOC-3266-2 – Revision 16 – August 2007
____________________________________________________________
6-30
6.1.9
Installing display drivers for new cards or an OmniBus device
If the display driver was already installed on T
RANS
F
ORM
A, then after expanding the system with additional com-
ponents a hardware check will detect the new device when switching on T
RANS
F
ORM
A. This is in particular the
case:
•
In an OmniBus configuration
after connecting an additional O
MNI
B
US
•
In a Processor configuration
after inserting additional graphic cards, O
MNI
S
CALERS
or input cards
The installation of the display drivers for the new device is started automatically.
Figure 6-5
New Hardware found and driver installation (in this case for an O
MNI
B
US
A18)
After the installation is finished you have to confirm
Finish
:
Figure 6-6
installation is finished
You will be prompted to restart T
RANS
F
ORM
A.
•
In an OmniBus configuration
confirm with
Yes
•
In a Processor configuration
, if inserting multiple new cards click
No
and just reboot one time manually
after the procedure explained above has been run through for all cards.
Figure 6-7
system settings change
If you inserted graphic cards in TransForm A you have to configure these graphic cards, see
section
3.5.2 Configuring the display driver
.
