Barco SP4K-B, Installation Manual

Page: 98 / 158

R5912128 /03 SP4K-B 98
8.1 Explaining the power states
Power states explained
The projector can have one of several power states, which you can recognize by the state of the power LED.
Projector
Power State
Behavior Power LED
Mains power off Projector is not powered Off
OFF mode The power button and GPI3 are powered (for remote power-on). Slowly blinking
RED
ECO mode Projector IP connection is active; touch display and image processing
are off. Full RED
READY mode Projector is fully powered and active; touch display is on (if available),
Web Communicator is active and light is OFF. Full GREEN
ON mode Projector is fully powered and active; touch display is on (if available),
Web Communicator is active and light is ON. Full GREEN
Going to ECO
mode Turning electronics and light source OFF. Blinking green
2 3 4 5 6 1
Image 8–1
1 Mains power off
2 OFF mode
3 ECO mode
4 READY mode
5 ON mode
6 Going to ECO mode
Switching between power states
You can change power state by using one of the following options:
• Pressing the Power button on the Cinema Controller (reference 1)
• Sending a wake-up signal to the GPI3 input for more than 0.5 seconds, but less than 2 (reference 2). 3
• Using the ECO menu on the touch display (if available).
• Using the Power menu in Web Communicator.
Projector Power Cycle
3. GPI3 works the same way as the power button. Thus take into account that sending a signal for more than 6 seconds will turn the
projector OFF instead.