Barco SIM 7QP HB, User Manual

Page: 125 / 206

7. Advanced
The item is focused
Image 7-134
2. Use the ← and → to select the level (from 1 to 6)
How to adjust the soft edge ?
1. Press Adjust
An Edit dialog box is displayed and the left side soft edge zone is selected. The default level is level 1.
2. Use the ← and → to select a point within the same level and side to be displaced
Note: The ↑ and ↓ can be used to switch to another level or to another side of the image.
3. Press ENTER to go to the Edit mode
4. Use the ↑ and ↓ arrows to select the desired fi eld
5. Press ENTER to edit the fi eld
The edit fi eld is put in the edit mode
6. Use the arrows or the digits to fi ll in the desired x position of the selected point (in this case the left top point of level 1)
7. Press ENTER to con fi rm
The selected point is displaced to the new position (x=100 ; Y=0).
8. Press BACK to exit
A dialog box is displayed. Press ENTER to con fi rm
All the points of the higher levels (level 2, ...) are altered by this adjustment. The points that belong to the
same level (level 1) remain in the same position (anchors).
7.8.5.3.4 Alpha planes
Alpha plane speci fi cation
An alpha plane is a bitmap fi le which will be applied to the image in order to obtain a desired soft edge. The fi le must be a .TIFF fi le
and it must have the same resolution as the projector’s native resolution.
Uploading an alpha plane fi le
Alpha planes must be uploaded in the following projector directory (accessible via FTP) :
/D/display/Softedge
The fi le must be named as follows :
alpha.tiff
R59770330 SIM 7QP SERIES 08/12/2014 121