Barco R9841020 Cine VERSUM Master, Installation Manual

Page: 32 / 161

5. Location of Controls
The status of the Plasma screen is indicated by a blue LED (3), located at the bottom on the right of the screen. In the same corner
an IR Sensor (2) is mounted to allow controlling the Cine VERSUM system via the screen.
Image 5-2
Cine VERSUM 50 controls
Controls function description
Ref. Function Description
1 Main Power Switch Switches the Cine VERSUM 50 in the Standby mode or operation mode. In these
modes, the Cine VERSUM 50 is controlled by the Cine VERSUM Master or remotely
on its own address.
2 Infra Red Receiver Infra Red reception diode for the IR signals from the IR transmitter to control the
Cine VERSUM System.
3 Standby LED Indicates the status of the Cine VERSUM 50, lights up in standby and operation
mode.
Table 5-2
5.3 On Cine VERSUM 80
Top view
The top side of the Cine VERSUM 80 is provided with the following controls:
Image 5-3
Controls function description
Ref. Function Description
1 Infra Red Receiver Infra Red reception diode for the IR signals from the IR transmitter. Allows
switching On/Off (Standby) of the projector separately and controlling
the Cine VERSUM System.
28 R5976468 CINE VERSUM SYSTEM 03112003